Experimental performance investigations of an elliptical hyperbolic non-imaging solar concentrator with trapezoidal surface receiver for process heat applications

The use of non-imaging collectors has a wide scope in process heat applications based on its performance and economics. An experimental investigation of trapezoidal/concave cavity surface receiver (TSR) for non-imaging solar concentrating collector is carried out in this paper. The implementation of surface/coil receiver instead of tubular receiver for non-imaging collector is presented in this paper. A TSR with helical coil is developed for non - imaging concentrating collector, Elliptical Hyperbolic Collector (EHC). Experiments are carried to estimate the thermal performance of the system under various operating conditions such as two operating modes: series and parallel modes of operation of the collector, two circulation modes: passive and active modes. The stagnation temperature of the trapezoidal/concave cavity surface receiver is measured to be 118 °C on a clear sunny day in October and 102 °C on a cloudy day in February. The daily performance tests are performed under different operating conditions. Based on the experimental study, for the flow rate of 0.03 kg/min and 0.5 kg/min, the fluid outlet temperature is estimated to be 87 °C at 768 W/m2 and 49 °C at 908 W/m2 respectively. The corresponding instantaneous efficiency was calculated to be 9% and 40% respectively. The numerical model is developed to predict the temperature of the fluid along the receiver. The pressure drop across a receiver is estimated to be 9.3 kPa for a flow rate of 0.5 kg/min. Exergy analysis of the system is carried out and it ranges between 10 and 20%. The costs involved in fabricating the EHC system are compared to that of a non-imaging concentrating collector (CPC) of same aperture area. An economic analysis of the system is also carried out to study the feasibility of the system based on the life cycle savings method by estimating the annual solar savings from the EHC system. The present system can be a suitable option for low and medium temperature process heat applications.