کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
8128317 1522992 2018 9 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Numerical investigation for simultaneous growth of hydraulic fractures in multiple horizontal wells
ترجمه فارسی عنوان
بررسی عددی برای رشد همزمان شکستگی های هیدرولیکی در چندین چاه افقی
کلمات کلیدی
شکستگی هیدرولیکی، شبیه سازی عددی، شکستن چند شکاف، روش انحلال انقطاع،
ترجمه چکیده
به تازگی توسعه فن آوری های شکستن چند بخشی به طور گسترده ای در مخازن غیر قابل نفوذ کم نفوذ برای افزایش تولید استفاده می شود. در این مقاله، ما یک مدل عددی سه بعدی را که موجب تغییر شکل ساختگی، جریان سیال و پارتیشن جریان شار حرارتی در چندین چاه می شود، به منظور شبیه سازی رشد همزمان شکست های هیدرولیکی در شکستن چندخاک در مخازن غیر متعارف اجرا می کنیم. برای حل مشکل به طور کامل، یک طرح عددی با حلقه های چهار لایه در این مدل اتخاذ می شود. شبیه سازی های عددی نشان می دهد که انتشار شکستگی نامتقارن در شکستن چند شکسته اتفاق می افتد و رشد لبه های شکستگی های داخلی به علت شدت دخالت استرس بین دو طرف سرکوب می شود. نتایج نشان می دهد که افت فشار ورودی بالاتر، که با طراحی ورودی محدود شده است، می تواند موجب گسترش عرضی شکستگی های داخلی شود. سپس مطالعات موردی برای بررسی تأثیر فاصله فاصله، فاصله فاصله و طرح شکسته بر روی رشد شکستگی در شکستن چند شکسته انجام می شود. نتایج نشان می دهد که با کاهش فاصله شکست تا حد معینی، افزایش کارایی شکستگی با افزایش تعداد شکست انجام نمی شود. مطالعات موردی نیز نشان می دهد که برای درمان موفق شکستگی، در طراحی باید یک حد ممکن از محدوده فاصله در نظر گرفته شود تا از کاهش شدید اثربخشی درمان جلوگیری شود. در مقایسه با طرح شکستگی همزمان، نتایج مطالعات نشان می دهد که طرح شکستگی زیپ، در ارتقاء پیچیدگی شکست و افزایش سطح ناحیه شکستی است که مطلوب برای افزایش تولید هیدروکربن است.
موضوعات مرتبط
مهندسی و علوم پایه علوم زمین و سیارات علوم زمین و سیاره ای (عمومی)
چکیده انگلیسی
Recently developed multi-well fracturing technologies are widely used in unconventional low-permeable reservoirs for enhancing production. In this paper, we have implemented a three-dimensional numerical model, which couples the rock deformation, fluid flow and the dynamical flux partition in multiple wellbores, to simulate the simultaneous growths of hydraulic fractures in multi-well fracturing at unconventional reservoirs. To resolve the fully-coupled problem, a numerical scheme with four-layer loops is adopted in this model. The numerical simulations reveal that the asymmetric fracture propagations occur in multi-well fracturing, and the lateral growths of interior fractures are suppressed due to the intense inter-well stress interference. Results show that higher inlet pressure loss, achieved by limited entry design, is able to promote the lateral propagation of interior fractures. Then, case studies are performed to investigate the influences of fracture spacing, well spacing and fracturing scheme on fracture growths in multi-well fracturing. The results reveal that, when decreasing fracture spacing to a certain degree, the fracturing efficiency will not be promoted further by increasing fracture number. The case studies also indicate that, for successful fracturing treatment, a possible lower limit of well spacing should be considered in design, to avoid a sharp reduction of effectiveness in treatment. Compared to simultaneous fracturing scheme, study results show that zipper fracturing scheme has a better performance in promoting the fracture complexity and increasing the fracture surface area, which is favorable to enhance hydrocarbon production.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Journal of Natural Gas Science and Engineering - Volume 51, March 2018, Pages 44-52
نویسندگان
, , , , ,