Analysis of the wellhead growth in HPHT gas wells considering the multiple annuli pressure during production

In high-temperature and high-pressure (HPHT) gas wells, the wellhead growth caused by temperature and pressure effects during production might damage the well integrity. A calculation model of the wellhead growth produced by temperature and pressure effects was built. For the case well, the maximum pressures of annulus A, B and C are 64 MPa, 48 MPa and 38 MPa, respectively. The maximum production and intervention time are 114.5 × 104 m3/d and 540 d, respectively. Based on the calculation process, the maximum wellhead growth is 412.7 mm. The axial load caused by the multiple annuli pressure is second only to that caused by the casing axial temperature difference. Wellhead growth increases with the annulus fluid thermal expansion coefficient and decreases with the annulus fluid isothermal compression coefficient. The increasing annulus temperature difference might aggravate the effect of annulus fluid thermal properties on the wellhead growth. Selecting the casing with greater wall thickness and lower thermal expansion coefficient can reduce the wellhead growth. The annulus width has little effect on the wellhead growth while the annulus length will significantly change the wellhead growth. The wellbore multiple annuli pressure can increase the wellhead growth prominently. The annulus pressure management shall be introduced into the production. Optimizing the well structure and production plan and installing the wellhead monitoring equipment contribute to mitigating the wellhead growth.