کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
8128591 1523007 2016 8 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Dynamic modeling of the crack deformation in dry/gas-saturated rocks with increasing normal stress
ترجمه فارسی عنوان
مدل سازی دینامیکی تغییر شکل کرک در سنگ های خشک / گاز اشباع با افزایش استرس طبیعی
کلمات کلیدی
ترک، دولت استرس، مدل سازی پویا، نسبت عرض خم شدن تراکم ضخامت
ترجمه چکیده
ترک در سنگهای مخزن به طور گسترده ای وجود دارد و تغییر حالت تنش می تواند منجر به تغییر شکل یا حتی بسته شدن آن شود که تأثیر زیادی بر تجمع و نفوذ نفت و گاز در سنگ های مخزن دارد. به منظور بررسی تغییر شکل ترک در شرایط تنش های مختلف، یک روش مدل سازی پویای دو بعدی برای تغییر شکل ترک در افزایش شدت فشرده سازی به طور نرمال به سطح ترک خوردگی پیشنهاد شده است تا شبیه سازی روند طبیعی ترک خوردن. تغییر شکل کرک برای به روز رسانی مدل هندسی سنگ های ترک خورده در هر مرحله بارگیری استخراج می شود. چنین روش پویایی مدل سازی با اندازه گیری سرعت نمونه های مصنوعی با ساختارهای کرک شناخته شده در تنش های مختلف اثبات شده است. مدلسازی دینامیکی ساختارهای مختلف کرک به منظور عددی بررسی اثرات تخلخل اولیه کرک، نسبت عرض تراک و تراکم تراکم بر تغییر شکل ترک مربوطه استرس طراحی شده است. نتایج مدل سازی نشان می دهد که تخلخل کرک و نسبت عرض کراک به طور منفی با افزایش استرس طبیعی منفی کاهش می یابد، در حالی که تراکم عادی افزایش می یابد. سنگهای حاوی ترک هایی با نسبت مساوی کم تر، تراکم تر تراکم و (یا) تخلخل کیک بالاتر، حساسیت بیشتری نسبت به استرس دارند. برای ساختارهای مختلف ترک، ضریب حساسیت تنش تراکم تراکم تغییرات وسیعتری را نشان می دهد که نشان می دهد که ضریب حساسیت تنش تراکم کرک باید یک ویژگی بالقوه موثر برای شناسایی کمی و پیش بینی ترک در سنگ های زیرزمینی باشد.
موضوعات مرتبط
مهندسی و علوم پایه علوم زمین و سیارات علوم زمین و سیاره ای (عمومی)
چکیده انگلیسی
The crack widely exists in reservoir rocks and the change of the stress state may lead to its deformation or even closure, which has a great influence on the oil and gas accumulation and percolation in reservoir rocks. In order to investigate the crack deformation at different stress conditions, a two-dimensional dynamic modeling method for crack deformation under progressively increasing compressional stress normal to the crack surface is proposed to simulate the natural process of crack closing. The crack deformation is extracted to update the geometric model of cracked rocks at each loading step. Such dynamic modeling method is verified by the velocity measurement of synthetic samples with known crack structures at different effective stresses. Dynamic modelings of different crack structures are designed to numerically test the effects of initial crack porosity, crack aspect ratio and crack density on the stress-dependent crack deformation. The modeling results indicate that the crack porosity and the crack aspect ratio decrease negative-exponentially with the increase of normal stress, while the crack density decreases positive-exponentially as the normal stress increases. Rocks containing cracks with lower crack aspect ratio, higher crack density and (or) higher crack porosity have stronger stress sensitivity. For different crack structures, the stress sensitivity coefficient of crack density shows much more wide variation, which indicates that the stress sensitivity coefficient of crack density should be a potential effective attribute for quantitatively identifying and predicting cracks within the underground rocks.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Journal of Natural Gas Science and Engineering - Volume 34, August 2016, Pages 170-177
نویسندگان
, , , ,