Fabrication of hybrid organic-inorganic vertical microcavities through imprint technology Fulltext Access 5 Pages 2005
Experimental observation of the initiation process of friction-induced vibration under reciprocating sliding conditions Fulltext Access 5 Pages 2005
Development and validation of a mechanistic model to predict solid particle erosion in multiphase flow Fulltext Access 5 Pages 2005
An inclined plane test for the breakaway coefficient of rolling friction of rolling element bearings Fulltext Access 5 Pages 2005
Electron work function, adhesion, and friction between 3d transition metals under light loads Fulltext Access 5 Pages 2005
Influence of surfactant and salts on chemical mechanical planarisation of copper Fulltext Access 5 Pages 2005
Measurement and prediction of tape edge wear using accelerated wear testing Fulltext Access 5 Pages 2005
Improvement in instable analysis of heat inflation induced line-width after replacing pellicle with diamond film on reticle (photo-masks) Fulltext Access 5 Pages 2005
Analysis on the effect of parallel current path on the quality factor of CMOS spiral inductors for 1-10 GHz Fulltext Access 5 Pages 2005
Nanofabrication of protein-patterned substrates for future cell adhesion experiments Fulltext Access 5 Pages 2005
Comparative study of calixarene and HSQ resist systems for the fabrication of sub-20Â nm MOSFET device demonstrators Fulltext Access 5 Pages 2005
Increased plasma etch resistance of thin polymeric and photoresist films Fulltext Access 5 Pages 2005
Micromachining of organic polymers by X-ray photo-etching using a 10Â Hz laser-plasma radiation source Fulltext Access 5 Pages 2005
Rapid prototyping of two-dimensional photonic crystal devices by a dual beam focused ion beam system Fulltext Access 5 Pages 2005
Nanoscaled niobium trilayer technology, using temperature controlled pattern transfer Fulltext Access 5 Pages 2005
Improvement in the aspect ratio of fabricated minute dots by the volume change thermal lithography technique Fulltext Access 5 Pages 2005
Reduction in wear of metakaolinite-based geopolymer composite through filling of PTFE Fulltext Access 5 Pages 2005
A study on mild-to-severe wear transition due to inconformity of wear-induced shape Fulltext Access 5 Pages 2005
Erosion-corrosion of Fe- and Ni-based tubes and coatings in a fluidized bed test rig during exposure to HCl- and SO2-containing atmospheres Fulltext Access 5 Pages 2005
Characterization and estimation of tunnel barrier height in metallic single-wall carbon nanotube quantum dots Fulltext Access 5 Pages 2005
Optimization and experimentation of nanoimprint lithography based on FIB fabricated stamp Fulltext Access 5 Pages 2005
Electrochemical synthesis and fluorescence spectrum properties of silver nanospheres Fulltext Access 5 Pages 2005
The SOI planar photonic crystal fabrication: patterning of Cr using Cl2/O2 plasma etching Fulltext Access 5 Pages 2005
Comparing the tribological behaviour of an austenitic steel subjected to diverse thermal treatments Fulltext Access 5 Pages 2005
Effect of bridged cyclotriphosphazenes as lubricants on the tribological properties of a steel-on-steel system Fulltext Access 5 Pages 2005
A study on fullerene-acrylamide copolymer nanoball-a new type of water-based lubrication additive Fulltext Access 5 Pages 2005
Behavior of fullerene-like WS2 nanoparticles under severe contact conditions Fulltext Access 5 Pages 2005
Study on tribological properties and action mechanism of organic cadmium compound in lubricants Fulltext Access 5 Pages 2005
Oxide film formation in magnetized sliding steel/steel contact-analysis of the contact stress field and film failure mode Fulltext Access 5 Pages 2005
The effect of wear and corrosion on internal crystalline texture of carbon steel and stainless steel Fulltext Access 5 Pages 2005
Study of the impact of winding form and film thickness on thin-film inductors Fulltext Access 5 Pages 2005
Electrical characteristics of GaN-based metal-oxide-semiconductor (MOS) structures Fulltext Access 5 Pages 2005
Reservoir effect on electromigration mechanisms in dual-damascene Cu interconnect structures Fulltext Access 5 Pages 2005
Modeling of residual stresses in thin films deposited by electron beam evaporation Fulltext Access 5 Pages 2005
Correlation of electromigration defects in small damascene Cu interconnects with their microstructure Fulltext Access 5 Pages 2005
Qualitative and quantitative analysis of acoustomigration effects in SAW-devices Fulltext Access 5 Pages 2005
Electron back scattered diffraction study of acoustomigration damage in Al/Ti metallization for SAW devices Fulltext Access 5 Pages 2005
Terahertz radiation from narrow-gap semiconductors photoexcited by femtosecond laser pulses Fulltext Access 5 Pages 2005
TaN/Ta bilayer barrier characteristics and integration for 90 and 65Â nm nodes Fulltext Access 5 Pages 2005
Investigation of Ni/Co bilayer salicidation process for sub-40Â nm gate technology Fulltext Access 5 Pages 2005
Impact of dielectric stack and interface adhesion on mechanical properties of porous ultra low-k Fulltext Access 5 Pages 2005
Lateral solvent diffusion characterization of low k dielectric plasma damage and ALD barrier film closure Fulltext Access 5 Pages 2005
Silver metal organic chemical vapor deposition for advanced silver metallization Fulltext Access 5 Pages 2005
Bright red-to-yellow organic light-emitting devices based on polarization-induced spectral shifts and broadening Fulltext Access 5 Pages 2005
Focused ion beam lithography for two dimensional array structures for photonic applications Fulltext Access 5 Pages 2005
Fabrication of subwavelength aluminum wire grating using nanoimprint lithography and reactive ion etching Fulltext Access 5 Pages 2005
Utilizing self-assembled multilayers in lithographic processing for nanostructure fabrication: Initial evaluation of the electrical integrity of nanogaps Fulltext Access 5 Pages 2005
A hybrid CMOS-SET co-fabrication platform using nano-grain polysilicon wires Fulltext Access 5 Pages 2005
Fabrication of ultra-thin-film SOI transistors using the recessed channel concept Fulltext Access 5 Pages 2005
Novel resonant cantilever mass change detection and resonant frequency tuning Fulltext Access 5 Pages 2005
A systematic study of dry etch process for profile control of silicon tips Fulltext Access 5 Pages 2005
Fabrication error model and near field beam modulation analysis for phase step diffractive gratings Fulltext Access 5 Pages 2005
New method to correct eddy current in magnetic focusing-deflection system Fulltext Access 5 Pages 2005
Spin injection in double magnetic tunnel junctions: A tight-binding study Fulltext Access 5 Pages 2005
Modeling of a EEPROM device based on silicon quantum dots embedded in high-k dielectrics Fulltext Access 5 Pages 2005
Ab initio modeling of copper adhesion on regular BaTiO3(0Â 0Â 1) surfaces Fulltext Access 5 Pages 2005
Inter-granular magneto-resistance of a Fe3O4/CrO2 system with inversely polarized conduction electrons Fulltext Access 5 Pages 2005
The effect of precursor system on the resistivity and oxidation susceptibility of C/SiC nanocomposites en route to electronic grade nanomaterials Fulltext Access 5 Pages 2005
Influence of injection level of charge carriers in nanostructured porous silicon on electroluminescence quantum efficiency Fulltext Access 5 Pages 2005
Dark current characteristics of thermally treated contacts on GaN-based ultraviolet photodetectors Fulltext Access 6 Pages 2005