Sedimentation basin performance at highway construction sites

Sedimentation basins (SBs) are commonly used during highway construction for erosion and sedimentation pollution control as well as for attenuation of overland storm waters. In order to evaluate the sediment removal capacity of these SBs, four basins were selected for monitoring from a new highway construction that extends I-99 to I-80, in Pennsylvania. Between September 2004 and August 2005, ten sampling trips were conducted during which basin inlet and outlet water samples were obtained. The SB samples were analyzed for pH, color, turbidity, total suspended solids (TSS), volatile suspended solids (VSS), total and dissolved iron, magnesium, manganese, aluminum, calcium, sulfate and phosphate. The data showed peaks in concentrations of TSS, total aluminum, total manganese, total iron and total phosphate that closely correlated to localized rainfall peaks. For certain samples, the concentration of TSS in the outlet was higher than the TSS concentration at the basin inlet, suggesting sediment re-suspension. In general SBs managed high flows during wet weather events, but were not effective in capturing particulates. This paper discusses the need for Best Management Practices (BMPs) for the design of SBs that reflect contemporary concerns for management of particle removal and to control the release of particulate-bound metals. This paper also evaluates the water quality impacts of naturally occurring acidic drainages into SBs, as several acidic seeps with pH in the range of 5–6 and having high dissolved concentrations of metals (Fe, Mn, Mg and Ca), sulfate and phosphate were observed draining into the SBs.