کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
1199077 1493559 2014 7 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Optimization of a microfluidic electrophoretic immunoassay using a Peltier cooler
موضوعات مرتبط
مهندسی و علوم پایه شیمی شیمی آنالیزی یا شیمی تجزیه
پیش نمایش صفحه اول مقاله
Optimization of a microfluidic electrophoretic immunoassay using a Peltier cooler
چکیده انگلیسی


• A Peltier cooler was used to minimize dissociation during an affinity separation.
• Separation temperatures tested were 26, 25, 23, and 21 °C.
• At low temperatures, high separation voltages were permitted.
• Optimum conditions were lowest temperature and highest voltage.
• LOD improved by 10-fold using optimum conditions.

Successful analysis of electrophoretic affinity assays depends strongly on the preservation of the affinity complex during separations. Elevated separation temperatures due to Joule heating promotes complex dissociation leading to a reduction in sensitivity. Affinity assays performed in glass microfluidic devices may be especially prone to this problem due to poor heat dissipation due to the low thermal conductivity of glass and the large amount of bulk material surrounding separation channels. To address this limitation, a method to cool a glass microfluidic chip for performing an affinity assay for insulin was achieved by a Peltier cooler localized over the separation channel. The Peltier cooler allowed for rapid stabilization of temperatures, with 21 °C the lowest temperature that was possible to use without producing detrimental thermal gradients throughout the device. The introduction of cooling improved the preservation of the affinity complex, with even passive cooling of the separation channel improving the amount of complex observed by 2-fold. Additionally, the capability to thermostabilize the separation channel allowed for utilization of higher separation voltages than what was possible without temperature control. Kinetic CE analysis was utilized as a diagnostic of the affinity assay and indicated that optimal conditions were at the highest separation voltage, 6 kV, and the lowest separation temperature, 21 °C, leading to 3.4% dissociation of the complex peak during the separation. These optimum conditions were used to generate a calibration curve and produced 1 nM limits of detection, representing a 10-fold improvement over non-thermostated conditions. This methodology of cooling glass microfluidic devices for performing robust and high sensitivity affinity assays on microfluidic systems should be amenable in a number of applications.

ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Journal of Chromatography A - Volume 1367, 7 November 2014, Pages 154–160
نویسندگان
, , , ,