Advanced scripting for the automated profiling of two-dimensional gas chromatography-time-of-flight mass spectrometry data from combustion aerosol

• Automated compound classification for GCxGC-TOFMS data was developed.
• Results were qualitative and quantitative evaluated for type 1 and type 2 errors.
• Substance classes PAH, alkanes, benzenes, ester, ethers, etc. can be targeted.
• Classification of about 75% of the peaks of interest within real PM samples.

Multidimensional gas chromatography is an appropriate tool for the non-targeted and comprehensive characterisation of complex samples generated from combustion processes. Particulate matter (PM) emission is composed of a large number of compounds, including condensed semi-volatile organic compounds (SVOCs). However, the complex amount of information gained from such comprehensive techniques is associated with difficult and time-consuming data analysis. Because of this obstacle, two-dimensional gas chromatography still receives relatively little use in aerosol science [1], [2], [3] and [4]. To remedy this problem, advanced scripting algorithms based on knowledge-based rules (KBRs) were developed in-house and applied to GCxGC-TOFMS data. Previously reported KBRs and newer findings were considered for the development of these algorithms. The novelty of the presented advanced scripting tools is a notably selective search criterion for data screening, which is primarily based on fragmentation patterns and the presence of specific fragments. Combined with “classical” approaches based on retention times, a fast, accurate and automated data evaluation method was developed, which was evaluated qualitatively and quantitatively for type 1 and type 2 errors. The method's applicability was further tested for PM filter samples obtained from ship fuel combustion. Major substance classes, including polycyclic aromatic hydrocarbons (PAH), alkanes, benzenes, esters and ethers, can be targeted. This approach allows the classification of approximately 75% of the peaks of interest within real PM samples. Various conditions of combustion, such as fuel composition and engine load, could be clearly characterised and differentiated.