Using multiple short-end injections to develop fast electrophoretic separations—Applications in iodide analysis

The aim of this study was to develop a fast CE separation method by using multiple short-end injections in a capillary coated with quaternary ammonium chitosan (HACC), in order to determine the iodide content of pharmaceutical formulations. The BGE was composed of 20 mM tris(hydroxymethyl)aminomethane and 11 mM hydrochloric acid, at pH 8. The internal standard used was thiocyanate. Separations were performed in a fused silica capillary (32 cm total length, 8.5 cm effective length and 50 μm i.d.) coated with HACC and direct UV detection at 220 nm. EOF was modified by flushing the capillary with polymeric solution, resulting in a semi-permanent coating of controlled and stable EOF. The EOF was anodic at pH 8. Different strategies, using single and multiple injection short-end configurations, were studied to develop a CE method that resulted in a maximum number of iodide samples analyzed per hour: one plug and flush (Sflush) 35 samples/h, one plug without flush (SWflush) 76 samples/h, four plugs and flush (Mflush) 61 samples/h, and four plugs without flush (MWflush) 80 samples/h. Using the multiple injection configuration, it was possible to inject up to four plugs using spacer electrolytes with good separation efficiency and selectivity. The voltage application time needed to separate the eight peaks (iodide and thiocyanate) with MWflush was only 12 s. The method was validated and samples were analyzed using MWflush. Good linearity (R2 > 0.999); a limit of detection 0.4 mg L−1; intermediate precision better than 3.8% (peak area) and recovery in the range of 99–102% were obtained.