Cr–N–C multilayer film on 316L stainless steel as bipolar plates for proton exchange membrane fuel cells using closed field unbalanced magnetron sputter ion plating

To combine the advantages of chromium nitride (CrN) and amorphous carbon (a-C) film, this study proposes a novel Cr–N–C multilayer film on 316L stainless steel (SS316L) as bipolar plates for proton exchange membrane fuel cells (PEMFCs) using closed field unbalanced magnetron sputter ion plating (CFUBMSIP) method. The characterizations of Cr–N–C film are analyzed by X-ray photoelectron spectroscopy (XPS), X-ray diffractometry (XRD), and scanning electron microscopy (SEM). Scratch tests indicate that the adhesion strength between the film and SS316L substrate has been greatly improved which is beneficial to prevent the multilayer film from spalling. Interfacial contact resistance (ICR) between coated SS316L sheets and simulated gas diffusion layer (GDL) decreases to 2.64 mΩ cm2 at 1.4 MPa. Potentiodynamic results reveal that the anodic corrosion potential of coated samples is more positive than the operation potential and the cathodic passivation current density is only 0.61 μA cm−2 at 0.6 V. Potentiostatic test, contamination analysis and surface morphology results reveal that the substrate is well protected by the Cr–N–C film. This research demonstrates that the novel Cr–N–C film exhibits excellent ex-situ performance including strong adhesion strength, high corrosion resistance and low ICR.

Figure optionsDownload as PowerPoint slideHighlights
► A novel Cr–N–C multilayer film is deposited on SS316L as bipolar plates.
► Adhesion strength between the film and SS316L reaches 94.8 N.
► ICR is 2.64 mΩ cm−2 at 1.4 MPa and contact angle reaches 89.4°.
► Corrosion current density is 0.61 μA cm−2 at 0.6 V in cathodic environment.