Spontaneous molecular orientation of polyimides induced by thermal imidization (6). Mechanism of negative in-plane CTE generation in non-stretched polyimide films

The mechanism of negative coefficient of thermal expansion (CTE) generation for non-stretched polyimide (PI) films is proposed in this work. Negative CTE behavior was observed in some miscible binary blend films composed of a major fraction of a rod-like semi-crystalline PI derived from pyromellitic dianhydride (PMDA) with p-phenylenediamine (PDA) and flexible PIs based on 2,3,3′,4′-biphenyltetracarboxylic dianhydride (a-BPDA) whereas homo PMDA/PDA PI film shows a considerably low but a positive CTE value. The results suggest that the negative CTE generation is related to not only a considerably high extent of in-plane orientation of the PMDA/PDA chains but also to the crystallinity of the blends. The present work revealed that some other PIs, a poly(ester imide), and a polybenzoxazole system also display negative CTE and these systems also possess extremely high extents of in-plane chain orientation without exception. In addition to CTE, the morphologies were monitored as a function of imidization temperature for two PI systems, PMDA/2,2′-bis(trifluoromethyl)benzidine and PMDA/m-tolidine by wide-angle X-ray diffraction, FT-IR spectroscopy, birefringence, and film density measurements. The results suggested that the negative CTE phenomenon occurs when PI films possess very high extents of in-plane orientation and a less crystalline morphology simultaneously, thereby significant thermal expansion can be allowed to the thickness direction.

Negative in-plane (XY-direction) CTE phenomenon occurs in some non-stretched polyimide films cured in an adequate temperature range under a combined condition of significant in-plane orientation and a less crystalline morphology, by which preferential out-of-plane (Z-direction) thermal expansion can be allowed.Figure optionsDownload as PowerPoint slide