Implications of large elastic thicknesses for the composition and current thermal state of Mars

The martian elastic lithosphere thickness TeTe has recently been constrained by modeling the geodynamical response to loading at the martian polar caps and TeTe was found to exceed 300 km at the north pole today. Geological evidence suggests that Mars has been volcanically active in the recent past and we have reinvestigated the martian thermal evolution, identifying models which are consistent with Te>300 kmTe>300 km and the observed recent magmatic activity. We find that although models satisfying both constraints can be constructed, special assumptions regarding the concentration and distribution of radioactive elements, the style of mantle convection and/or the mantle's volatile content need to be made. If a dry mantle rheology is assumed, strong plumes caused by, e.g., a strongly pressure dependent mantle viscosity or endothermic phase transitions near the core–mantle boundary are required to allow for decompression melting in the heads of mantle plumes. For a wet mantle, large mantle water contents of the order of 1000 ppm are required to allow for partial mantle melting. Also, for a moderate crustal enrichment of heat producing, elements the planet's bulk composition needs to be 25 and 50% sub-chondritic for dry and wet mantle rheologies, respectively. Even then, models resulting in a globally averaged elastic thicknesses of Te>300 kmTe>300 km are difficult to reconcile with most elastic thickness estimates available for the Hesperian and Amazonian periods. It therefore seems likely that large elastic thicknesses in excess of 300 km are not representative for the bulk of the planet and that TeTe possibly shows a large degree of spatial heterogeneity.