Ash deposition behavior of upgraded brown coal in pulverized coal combustion boiler

Ash with a low melting point causes slagging and fouling problems in pulverized coal combustion boilers. Ash deposition on heat exchanger tubes reduces the overall heat transfer coefficient due to its low thermal conductivity. The purpose of this study is to evaluate the ash deposition for Upgraded Brown Coal (UBC) and bituminous coal in a 145 MW practical coal combustion boiler. The UBC stands for Upgraded Brown Coal. The melting temperature of UBC ash is relatively lower than that of bituminous coal ashes. Combustion tests were conducted on blended coal consisting 20 wt.% of UBC and 80 wt.% of bituminous coal. Before actual ash deposition tests, the molten slag fractions in those coal ashes were estimated by means of chemical equilibrium calculations. The calculation results showed the molten slag fraction for UBC ash reached approximately 90% at 1523 K. However, that for blended coal ash decreased to 50%. These calculation results mean that blending UBC with bituminous coal played a role in decreasing the molten slag fraction. This phenomenon occurred because the coal blending led to the formation of alumino-silicates compounds as a solid phase. Next, ash deposition tests were conducted using a practical pulverized coal combustion boiler. A water-cooled stainless-steel tube was inserted in locations at both 1523 K and 1273 K in the boiler to measure the amount of ash deposits. The results showed that the mass of ash deposition for blended coal did not greatly increase, compared with that for bituminous coal alone. Therefore, appropriately blending UBC with bituminous coal enabled the use of UBC without any ash deposition problems in practical boilers.

Research Highlights
► Ash deposition of Upgraded Brown Coal(UBC) with low ash melting point is evaluated.
► Blending UBC with bituminous coal played a role in reducing molten slag fraction.
► Solid phase of alumino-silicates were produced due to bituminous coal blending.
► Proper blending enables to be used without any ash deposition problems in boiler.