کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
2485 | 113 | 2007 | 12 صفحه PDF | دانلود رایگان |
The Laser Engineered Net Shaping (LENS™) method was used to fabricate porous Ti implants. Porous Ti structures with controlled porosity in the range of 17–58 vol.% and pore size up to 800 μm were produced by controlling LENS™ parameters, which showed a broad range of mechanical strength of 24–463 MPa and a low Young’s modulus of 2.6–44 GPa. The effects of porous structure on bone cell responses were evaluated in vitro with human osteoblast cells (OPC1). The results showed that cells spread well on the surface of porous Ti and formed strong local adhesion. MTT assay indicated LENS™ processed porous Ti provides a preferential surface for bone cell proliferation. Porous Ti samples also stimulated faster OPC1 cell differentiation compared with polished Ti sheet, which could be due to the change in cell morphology within the pores of Ti samples. More extracellular matrix and a higher level of alkaline phosphatase expression were found on the porous samples than on the Ti sheet. This can be beneficial for faster integration of porous implant with host bone tissue. The results obtained also indicated that a critical pore size of 200 μm or higher is needed for cell ingrowth into the pores, below which OPC1 cells bridged the pore surface without any growth in the pores.
Journal: Acta Biomaterialia - Volume 3, Issue 6, November 2007, Pages 1007–1018