Withstand Pressure of a Simple Fibrin Glue Sealant: Experimental Study of Mimicked Sellar Reconstruction in Extended Transsphenoidal Surgery

BackgroundTo examine the strength and tolerance of the fibrin glue sealant in a situation of extended transsphenoidal surgery. The withstand pressure of fibrin glue sealant was measured using a simple sellar reconstruction model.MethodsA 15-mm diameter hole at the bottom of a 51-cm high cylinder was covered with a Gore-Tex (Gore-Tex, Tokyo, Japan) sheet. A small plate was placed on the center for a brief fixation, and 3 mL of fibrin glue was applied over the entire bottom. Then water was gradually filled in five cylinders, and the water level at leakage was measured as withstand pressures at 10 minutes and 24 hours after sealant application. The stability of the sealant under pressures of 20 and 30 cm H2O for 12 hours was also examined.ResultsThe median initial withstand pressure at 10 minutes was 32 cm H2O (n = 5), and was significantly increased to 47.5 cm H2O after 24 hours (n = 4). In four of five cylinders, fibrin glue sealants were stable against a pressure of 20 cm H2O for 12 hours and 30 cm H2O for the next 12 hours.ConclusionsThe withstand pressure of simple fibrin glue sealant without other biological reactions could be estimated to be more than 20 cm H2O after application, and increased to more than 40 cm H2O after 24hours. These data are practical for neurosurgeons to comprehend the strength and limit of fibrin glue sealant and suggests the importance to control the intracranial pressure to less than 20 cm H2O, especially for the first 12 to 24 hours.