Distribution of legacy and emerging semivolatile organic compounds in five indoor matrices in a residential environment

• SVOCs indoors can be characterized using a combination of air and dust samples.
• Legacy SVOCs are in equilibrium between indoor air, floor and surface dust.
• Dust has high within-room spatial heterogeneity.
• Multimedia levels of current SVOCs cannot be estimated from single measurements.

Seven types of indoor samples, covering five indoor matrices, were collected in a residential room, and analyzed for five classes of semivolatile organic compounds (SVOCs). The goal was to improve the understanding of the relationship between indoor air, surface films and dust, based on differences in sources, physicochemical properties, and indoor environmental characteristics. Comparisons of the five matrices (gas- and particle-phase air, floor dust, surface dust/films and window films) demonstrated that within our test room a semi-quantitative measurement of the SVOC distributions and concentrations could be obtained by air, and composite dust or furniture surface wipes. Dust concentrations varied within the room, and spot samples were not necessarily representative of the average room conditions.Polyurethane foam passive air samplers (PUF-PAS) successfully quantified the total air concentrations of the studied SVOC compound groups, as indoor air concentrations were dominated by gas-phase compounds, however air concentrations of individual particle-bound compounds had higher uncertainty. Measured concentrations of dust/surfaces could be used to estimate air concentrations of legacy SVOCs, demonstrating equilibrium in the room. However, air concentrations of current-use compounds (flame retardants, polycyclic aromatic hydrocarbons (PAHs)) could not be estimated from dust/surface concentrations, demonstrating the influence of ongoing primary emissions and non-equilibrium status in the room.