Speciation of scandium and gallium in soil

A method for the speciation of scandium and gallium in soil has been developed. The sequential extraction scheme of Tessier et al. for heavy metals was examined for the scandium and gallium separation. The regents proposed by Tessier were used for the extraction, and only for the residual fraction the HClO4 was replaced with H2SO4. The optimum conditions for leaching scandium and gallium from the soil were chosen for each fraction. Very sensitive, spectrophotometric methods based on the mixed complexes of Sc(III) and Ga(III) with Chrome Azurol S and benzyldodecyldimethylammonium bromide were applied for the scandium and gallium determination after their separation by solvent extraction. 100% mesityl oxide and a 0.5 M solution of 2-thenoyltrifluoroacetone in xylene were chosen for the extraction of scandium and butyl acetate was selected for gallium. Soil samples from two different regions of Poland were the object of this research. The content of scandium and gallium found in the individual fractions of Upper Silesia soil (industrial region) was [in μg g−1] Sc: I, 1.52; II, 0.53; III, 7.78; IV, 1.79; V, 0.20; Ga: I, 24.7; III, 29.2; IV, 35.4; V, 6.9. In Podlasie soil (agricultural region), the content of both elements was clearly lower. The total content of scandium and gallium in the five soil fractions was in good correlation with the total content of these elements in the soils found after HF–H2SO4 digestion. Analysis using the ICP-OES method gave comparable results.