Properties of oregano (Origanum vulgare L.), citronella (Cymbopogon nardus G.) and marjoram (Majorana hortensis L.) flavors encapsulated into milk protein-based matrices

Encapsulating properties of skimmed milk powder (SMP) and whey protein concentrate (WPC) for the coating of the essential oil (EO) of oregano (Origanum vulgare L.) and aroma extracts (AE) of citronella (Cymbopogon nardus G.) and sweet marjoram (Majorana hortensis L.) by spray-drying were evaluated. The efficiency of microencapsulation expressed as a percentage of flavoring entrapped into the microcapsules varied from 54.3% (marjoram in WPC) to 80.2% (oregano in SMP). The content of flavoring remaining on the surface of encapsulated oregano EO was remarkably lower (1.1% and 1.4%) as compared with citronella (11.2% and 15.2%) and marjoram (16.7% and 22.1%) AEs encapsulated in SMP and WPC matrixes, respectively. Consequently, the changes in the composition of individual flavor compounds during encapsulation were considerably smaller for oregano EO as compared with citronella and marjoram AEs. The release of aroma compounds from the encapsulated products was assessed by solid phase microextraction (SPME) of headspace volatiles and their analysis by gas chromatography; some differences were observed between the analysed products. However, the effect of SPME fiber polarity was another important factor affecting the amount of extracted aroma compounds from encapsulated flavors. The percentages of nonpolar aliphatic terpenes were higher in the extracts obtained by nonpolar polydimethylsiloxane or bipolar polydimethylsiloxane–divinylbenzene fibers, while the content of oxygenated constituents in most cases was higher on the polar polyacrylate fiber. The latter extracted lower amounts of volatiles during 10 min exposure. The scanning electron microscopy and particle size analysis revealed that microcapsules were well-formed spherically shaped particles; however, SMP coated products had smoother surface as compared to WPC, containing more dents and wrinkles on the capsule surface. Particle size varied from 6 to 280 μm for SMP and from 2 to 556 μm for WPC microencapsulated products.