A modified 3D algorithm for road traffic noise attenuation calculations in large urban areas

- A 3D traffic noise attenuation calculation method is presented to simulate the noise distribution.
- Buildings volume ratio and area ratio of the projection of the buildings are taken into consideration.
- It is recommended that 5° is the most appropriate scanning angle for environmental noise calculation.
- The algorithm is expected to be applied in projects requiring large area noise simulations.

The primary objective of this study is the development and application of a 3D road traffic noise attenuation calculation algorithm. First, the traditional empirical method does not address problems caused by non-direct occlusion by buildings and the different building heights. In contrast, this study considers the volume ratio of the buildings and the area ratio of the projection of buildings adjacent to the road. The influence of the ground affection is analyzed. The insertion loss due to barriers (infinite length and finite barriers) is also synthesized in the algorithm. Second, the impact of different road segmentation is analyzed. Through the case of Pearl River New Town, it is recommended that 5° is the most appropriate scanning angle as the computational time is acceptable and the average error is approximately 3.1 dB. In addition, the algorithm requires only 1/17 of the time that the beam tracking method requires at the cost of more imprecise calculation results. Finally, the noise calculation for a large urban area with a high density of buildings shows the feasibility of the 3D noise attenuation calculation algorithm. The algorithm is expected to be applied in projects requiring large area noise simulations.

113