Temperature- and pH-responsive photosensitization activity of polymeric sensitizers based on poly-N-isopropylacrylamide

We previously reported that a copolymer consisting of N-isopropylacrylamide (NIPAM) and benzophenone (BP) units, behaves as a photosensitizer showing temperature-controlled oxygenation activity in water (J. Am. Chem. Soc. 2006, 128, 8751). This polymer shows a heat-induced oxygenation enhancement at low temperature region (5-20 °C), while showing a heat-induced oxygenation suppression at high temperature region (20-60 °C), resulting in an off-on-off activity profile against the temperature window. This is driven by a heat-induced phase transition of the polymer from coil to micelle and then to globule states. In the present work, effects of adding an amine component (N-[3-(dimethylamino)propyl]acrylamide: DMAPAM) to the polymer on the sensitization activity were studied, where the relationship between the phase transition behavior and the activity was clarified by several spectroscopic analyses. The polymers, poly(NIPAMx-co-BPy-co-DMAPAMz), show activity controlled by temperature and pH. The off-on-off activity profile shifts to higher temperature with a pH decrease. This is because protonation of the DMAPAM units leads to an increase in the polymer polarity and, hence, the polymer aggregates at higher temperature. In addition, increase in the DMAPAM content of the polymer leads to further shift of the activity profile. In contrast, at pH < 8, no activity enhancement is observed because complete protonation of the DMAPAM units suppresses polymer aggregation.