کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
5203475 | 1381932 | 2008 | 7 صفحه PDF | دانلود رایگان |
A small-scale loading frame was used to apply tensile and compressive stresses to glass vinyl ester and glass polyester laminates in a cone calorimeter under a heat flux of 75Â kWÂ mâ2. It was found, for the first time, that stress has a small but significant effect on the fire reaction properties. Increasing tensile stress increased heat release rate and smoke production while shortening the time-to-ignition. Compressive stress had the reverse effect. This was attributed to the fact that tensile stress promotes the formation of matrix microcracks, facilitating the evolution of flammable volatiles. This hypothesis is further supported by the observation that stress has the greatest effect on the early heat and smoke release peaks, with a lower effect on the final 'run-out' values.Stress rupture (time-to-failure) curves were produced for tension and compression. In tension, the behaviour was fibre dominated, with times-to-failure being roughly 10 times those in compression. Compressive failure involved resin dominated local fibre kinking, initiated near to the rear face of the specimen. The failure time was determined by a significant proportion of the specimen reaching its glass transition temperature.
Journal: Polymer Degradation and Stability - Volume 93, Issue 10, October 2008, Pages 1877-1883