In vitro cytotoxicity evaluation of nano-carbon particles with different sp2/sp3 ratios

- NCs with different sp2/sp3 ratios have been successfully prepared by annealing treatment.
- NCs with different sp2/sp3 ratios show good osteogenic capacity and lower immune response.
- The good cytocompatibility of NCs is mainly dependent on its surface charge.

Graphitization occurs during the long-term service of a diamond-like carbon (DLC) modified artificial joint. Then, DLC wear debris, which are carbon particles with different sp2/sp3 ratios and sizes ranging from the nano- to micro-meter scale produced. In this paper, to promote the application of DLC coating for artificial joint modification, the cytotoxicity of DLC debris (nano-carbon particles, NCs) with different sp2/sp3 ratios was studied. The microstructure and physical characteristics of NCs with different sp2/sp3 ratios were investigated by Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), Transmission Electron Microscope (TEM) and Dynamic Light Scattering (DLS). Meanwhile, osteoblasts and macrophages were applied to characterize the cytotoxicity of the NCs. In vitro cytotoxicity assay results indicated that cells incubated with NCs of different sp2/sp3 ratios had greater osteogenic capacity, and these particles caused a weaker immune response in comparison with CoCrMo particles. Taken together, the results indicated that NCs with different sp2/sp3 ratios presented a good cytocompatibility than CoCrMo particles. But no significant differences were observed among NCs with different sp2/sp3 ratios. The better cytocompatibility of NCs is mainly attributable to their surface charge.