کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
5483845 | 1522782 | 2017 | 9 صفحه PDF | دانلود رایگان |
- Without drill string rotation, better hole cleaning performance was observed with the oil-based mud compared to the water-based mud with similar viscosity profile.
- With the presence drill string rotation, hole cleaning performance of both the muds was nearly the same.
Cuttings transport is a topic of great interest in the oil and gas drilling industry. Insufficient cuttings transport leads to several expensive problems. Knowledge and selection of the drilling fluids is one of the important factor for efficient hole cleaning. It has been observed, however, that the hole cleaning performance of drilling fluids can be different even if the fluid rheological properties are similar as measured in accordance with API specifications. The reasons for stated difference in the behavior of drilling fluids are not well understood. The main objective of present work is to evaluate hole cleaning efficiency of an oil-based drilling fluid (OBM) and a water-based drilling fluid (WBM) whose viscosity profiles are similar as per API specifications.Hole cleaning efficiency of an oil-based drilling fluid and a water-based drilling fluid whose viscosity profiles are similar was investigated. The fluids tested were industrial fluids used in the field and were sent to us after reconditioning. Experimental studies were performed on an advanced purpose-built flow-loop by varying flow velocities and drill string rotation rates. The flow loop had a 10Â m long annulus section with 4â³ inner diameter wellbore and 2â³ outer diameter fully eccentric drill string. Pressure drop and sand holdup measurements were reported. Rheological investigations of the same fluids were used to understand the difference in the behavior of the drilling fluids tested. Higher pressure drop was observed for WBM compared to OBM, and for both fluids, the pressure drop increased with drill string rotation speed. In case of no drill string rotation, better hole cleaning performance was observed with the oil-based fluid compared to the water-based fluid. With the presence of drill string rotation, hole cleaning performance of both the fluids was nearly the same.
Journal: Journal of Petroleum Science and Engineering - Volume 159, November 2017, Pages 49-57