Regular ArticleEstimation of nicotine and tar yields from human-smoked cigarettes before and after the implementation of the cigarette ignition propensity regulations in Canada

In 2005, Human-Smoked (HS) tar and nicotine yields from commercial Canadian cigarettes were determined using a part filter analysis method to obtain estimates representative of human smoking behavior. In 2006, new cigarette designs were introduced to ensure compliance with the Canadian Low Ignition Propensity (LIP) regulations. It was not known how the changes in product design would affect HS yields. To assess the impact of the cigarette design modifications on HS yields, a further group of Canadian smokers was recruited for smoking the modified version of 10 products previously assessed. No differences in estimated HS tar yields were found between products following product modification. The HS nicotine yield was different for one product. In general, HS yields were higher than ISO machine yields while Canadian intense machine yields were more representative of the maximum HS yields. The same product ranking order was obtained for HS yields and the two machine yields but differences between the mean HS yields and ISO yields were smaller as the product ISO yields increased. Higher HS yields were measured when products were smoked by male smokers. The methodology used in this study showed the wide range of HS yields obtained by smokers as well as a good degree of stability in average HS yields just before and after the introduction of LIP regulations.