کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
593452 | 1453939 | 2013 | 8 صفحه PDF | دانلود رایگان |
• Aculyn™ 22 and Aculyn™ 33 are good foamers.
• Solution properties can be controlled by the polymer and salt concentrations.
• Solutions of A22 have higher bulk viscosity at the same composition as A33.
• A33 has higher surface viscoelasticity at the same bulk viscosity as A22.
• The foam drainage kinetics for these solutions is determined by the bulk viscosity.
Experimental investigations of both bulk and surface rheology of solutions of commercially available polymers Aculyn™ 22 and Aculyn™ 33 in presence of sodium chloride are performed in a wide range of the polymer and salt concentrations. It is shown that the bulk viscosity and the surface viscoelastic modulus of solutions of both polymers increases with the increase of polymer concentration and the decrease of the salt concentration. Solutions of both polymers demonstrate very good foamability and form stable foams. Foam drainage is governed mainly by the bulk viscosity when the latter is in the range of 100–500 mPa s.
Foam drainage kinetics depends on concentration of polymer and salt.Figure optionsDownload as PowerPoint slide
Journal: Colloids and Surfaces A: Physicochemical and Engineering Aspects - Volume 434, 5 October 2013, Pages 268–275