Microbubble formation using asymmetric Shirasu porous glass (SPG) membranes and porous ceramic membranes-A comparative study

We have recently proposed a new method for generating uniformly sized microbubbles from Shirasu porous glass (SPG) membranes with a narrow pore size distribution. In this study, to obtain a high gas permeation rate through SPG membranes in microbubble formation process, asymmetric SPG membranes were used. At the transmembrane/bubble point pressure ratio of less than 1.50, uniformly sized microbubbles with a bubble/pore diameter ratio of approximately 9 were generated from an asymmetric SPG membrane with a mean pore diameter of 1.58 μm and a skin-layer thickness of 12 ± 2 μm at a gaseous-phase flux of 2.1-24.6 m3 m−2 h−1, which was much higher than that through a symmetric SPG membrane with the same pore diameter. This is mainly due to the much smaller membrane resistance of the asymmetric SPG membrane. Only 0.27-0.43% of the pores of the asymmetric SPG membrane was active under the same conditions. The proportion of active pores increased with a decrease in the thickness of skin layer. In contrast to the microbubble formation from asymmetric SPG membranes, polydispersed larger bubbles were generated from asymmetric porous ceramic membranes used in this study, due to the surface defects on the skin layer. The surface defects were observed by the scanning electron microscopy and detected by the bubble point method.