Investigation on influential factors of engineering design of geothermal heat exchangers

• Describe the type of heat exchange tube and corresponding characteristics.
• Present the interior and exterior heat transfer models of borehole.
• Demonstrate an engineering project which employs ground source heat pump system.
• Analyse every parameter that influences the design size of ground heat exchangers.
• Illustrate the significance of optimizing ground heat exchangers.

The research on heat transfer models of geothermal ground heat exchangers (GHEs) of ground-coupled heat pump (GCHP) system has recently advanced greatly. However, although it is important to optimize the design size of GHEs for reducing the total length of GHEs, the optimization of GHEs by means of models is a little. This paper describes the interior simulation models of borehole in which single U-tube and double U-tubes are each buried. The analytical solutions concerning the borehole's exterior heat transfer are given. All the factors that exert influences on the design size of GHEs are described based on the results of the heat transfer models. These significant parameters consist of the centre to centre distance of the U-tube, thermal conductivity of the backfill material, distance of adjacent boreholes, types of circulating liquid or underground medium, arrangement of boreholes, and the minimum temperature of the circulating liquid which enters the heat pump. Using the simulation models and computer programming, the influence degrees of the above factors are discussed in terms of the adoption of different values or types. Therefore, the initial cost and the economic performance of the system are respectively dropped and improved. The investigation on optimization of GHEs is favourable for the further development of GCHP technology.