کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
6456889 | 1420651 | 2017 | 7 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: A broadband Pb-chalcogenide/CdS solar cells with tandem quantum-dots embedded in the bulk matrix (QDiM) absorption layers by using chemical bath deposition A broadband Pb-chalcogenide/CdS solar cells with tandem quantum-dots embedded in the bulk matrix (QDiM) absorption layers by using chemical bath deposition](/preview/png/6456889.png)
- PbS and PbSe films with quantum dots embedded in matrix morphologies are obtained by using chemical bath deposition.
- A PbSe/PbS stacked tandem structure is proposed to enhance the efficiency of PbS/CdS thin films solar cells.
- The Introduction of PbSe layer can enhance the spectra absorption both in the visible and near-infrared regions.
- An enhancement of power conversion efficiency (PCE) of 4.2% has been achieved with a high short current density of 40Â mA/cm2.
In this paper we have presented a power conversion efficiency (PCE) enhanced Pb-chalcogenide/CdS quantum dots (QDs) solar cells with novel tandem absorption layers synthesized by using chemical bath deposition (CBD) method. The tandem absorption layer is assembled by orderly stacking PbS-QDs layer, PbS-QDiM layer and PbSe-QDiM layer. Compared to single layer PbS-QDs/CdS solar cells, the solar cell with double-tandem layers (PbS-QDiM/QDs) shows the highest short current density (Jsc) of 47.5Â mA/cm2 due to smoothing of the photo-generated carrier transportation and enhancing the absorption in the visible region 530-800Â nm. However, the decreased open circuit voltage (Voc) of 0.14Â eV results in a low power conversion efficiency (PCE) of 2.2%. The triple-tandem absorber (PbSe-QDiM/PbS-QDiM/QDs) enhances the spectra absorption both in the visible (500-800Â nm) and near-infrared (1000-1700Â nm) regions, resulting in a higher short current density (Jsc) of 40Â mA/cm2, while keeping a relatively large open circuit voltage (Voc) of 0.28Â eV. Through an architectural modification, an enhancement of power conversion efficiency (PCE) of 4.2% has been achieved.
299
Journal: Solar Energy Materials and Solar Cells - Volume 172, December 2017, Pages 117-123