کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
647118 | 1457176 | 2012 | 9 صفحه PDF | دانلود رایگان |

Considering hydrogen as a clean alternative fuel for engines, this paper is to develop a procedure to add hydrogen in an intake manifold and to design an exhaust gas recirculation (EGR) system for a direct injection diesel engine. The cylinder gas pressure, air mass flow, fuel mass flow, and emissions (such as CO, CO2, HC, NOX, and smoke) were measured under various engine loads and 0%–40% EGR ratios adjusting the hydrogen-energy-share ratio at 0%–20%, meaning that the energy of hydrogen replaced 0%–20% that of diesel fuel. The combustion characteristics such as cyclic variations, heat release rate, brake thermal efficiency, and specific fuel consumption (SFC) were determined. The results show that the variation coefficient values of indicated mean effective pressure (IMEP) are from 0.9% to 2.8%. The rate of decrease in the smoke emission is 37.6%, and that in the NOX emission is 59.5% for a 60% load, 40% EGR ratio, and 20% added hydrogen.
► We use H2/diesel dual fuel and EGR to investigate the engine by energy-share method.
► The H2/diesel mixtures and EGR increase the ignition delay slightly.
► Adding hydrogen increases pressures and heat release rates but EGR decreases them.
► Coefficients of variation of IMEP are from 0.9% to 2.8% adding hydrogen and EGR.
► Maximum decrease rate in smoke emission is 37.6% and that in NOX emission is 59.5%.
Journal: Applied Thermal Engineering - Volume 42, September 2012, Pages 154–162