کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
658351 | 1458082 | 2013 | 10 صفحه PDF | دانلود رایگان |
عنوان انگلیسی مقاله ISI
A fast simulation of transient metal flow and solidification in a narrow channel. Part II. Model validation and parametric study
دانلود مقاله + سفارش ترجمه
دانلود مقاله ISI انگلیسی
رایگان برای ایرانیان
کلمات کلیدی
موضوعات مرتبط
مهندسی و علوم پایه
مهندسی شیمی
جریان سیال و فرایندهای انتقال
پیش نمایش صفحه اول مقاله
چکیده انگلیسی
The numerical algorithm developed in Part I is applied to a problem involving transient flow and solidification of a molten metal in a narrow gap, especially in the ventilation channels of die-cast dies. The presented algorithm is based on the lubrication approximation where the 2-D in-plane equations are obtained after integrating the 3-D flow equations. Applying heat balance over the control volume yields the accompanying temperature equation. These equations were applied to approximate flow and solidification in the narrow sections of a die-cast die. The numerical algorithm was verified by comparing the results with the ones obtained from the commercial software FLOW3D®, and the actual die-cast parts. Solidification characteristics were verified by measuring SDAS (secondary dendrite arm spacing). A parametric study explored the dependence of the metal flow-length in the channel on factors such as channel thickness, entrance metal velocity, and wall temperature. The presented algorithm was successfully implemented with significant savings in CPU time.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: International Journal of Heat and Mass Transfer - Volume 60, May 2013, Pages 806-815
Journal: International Journal of Heat and Mass Transfer - Volume 60, May 2013, Pages 806-815
نویسندگان
Alexandre Reikher, Krishna M. Pillai,