Seismic behavior of 3-D ECC beam-column connections subjected to bidirectional bending and torsion

Special moment resisting frames (SMF) are commonly used in low- and medium-rise buildings located in regions of high seismicity. Although adequate performance of this seismic force resisting system was observed in prior earthquakes in terms of protecting buildings from collapse, the formation of plastic hinges in the beams and columns causes irreparable damage to the beam-column connections. Recently, interest in using fiber-reinforced concrete (FRC) has been growing to enhance energy absorption capacity and damage tolerance of beam-column connections and other components in reinforced concrete (RC) buildings. Prior research has mostly focused on the application of steel FRC (SFRC) in 2-D beam-column connections. However, little is known about the performance of exterior beam-column connections that are usually subjected to more complex loading during an earthquake, involving bi-directional bending and torsion of the column. In addition to the loading, the geometry of the connection requires a more involved test setup (i.e., with an out-of-plane beam and proper boundary conditions). In this research, the use of engineered cementitious composites (ECC) in 3-D exterior beam-column connections is investigated experimentally to improve building seismic performance. ECC is a special class of high-performance fiber-reinforced cementitious composites (HPFRCC) that, compared to conventional concrete, exhibits higher tensile ductility, energy absorption and shear resistance, in addition to improved bond performance with reinforcing steel (rebar). To understand the performance of exterior beam-column connections under complex loading conditions, scaled 3-D specimens were constructed and tested under simulated seismic loads. To improve the performance of the connections, conventional RC was replaced with reinforced ECC (RECC) that extends from the panel zone to the adjoining beams and columns to cover the potential plastic hinge regions. This paper discusses the loading protocols, the test setup for 3-D exterior beam-column connections, and the improvement in the joint behavior with the application of RECC as compared to conventional RC. The results suggest that the efficient use of ECC in the potential plastic hinge regions can improve the capacity and damage tolerance of beam-column connections under realistic seismic loading conditions.