Solution-processed zinc oxide nanoparticles as interlayer materials for inverted organic solar cells

This paper describes inverted bulk heterojunction organic solar cells featuring solution-processed zinc oxide nanoparticles (ZnO NPs) as an electron extraction layer, prepared at relatively low annealing temperatures (≤150 °C). A solution of ZnO NPs (average size: 25 nm) was prepared using a wet grinding method. When the ZnO interlayer was present in the solar cell, the vertical phase separation of the active layers prepared with and without solvent annealing exhibited similar gradient concentrations and, therefore, similar photocurrent generation, both of which were superior to those of conventional devices incorporating a poly(3,4-ethylenedioxythiophene):poly(styrene sulfonic acid) (PEDOT:PSS) hole extraction layer. We attribute this vertical phase separation to the similar surface energies of the fullerene derivative and the ZnO interlayer. Under simulated air mass (AM) 1.5 G illumination at 100 mW cm−2, the power conversion efficiency of the optimized device was approximately 4%.

Figure optionsDownload as PowerPoint slideHighlights
► Simple and cheap method was demonstrated for the preparation of ZnO nanoparticle.
► Efficient inverted organic solar cells fabricated by utilizing the ZnO interlayer.
► Both solidification treatments of active layer given similar gradient concentration.
► Comparable power conversion energy achieved with and without solvent annealing.