کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
8085687 1521800 2018 16 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Improved liquid foam-bed photobioreactor design for microalgae cultivation
ترجمه فارسی عنوان
طراحی فتوبایراتورتور مایع فوم مایع بهبود یافته برای کشت میکروالاها
موضوعات مرتبط
مهندسی و علوم پایه مهندسی انرژی انرژی های تجدید پذیر، توسعه پایدار و محیط زیست
چکیده انگلیسی
The liquid foam-bed photobioreactor is a recently developed photobioreactor concept that allows for cost reduction in microalgae cultivation. Long term operation was not yet achieved, due to degradation of the surfactant. In this study, Pluronic F68 was applied for foam stabilization. In order to compensate for the low algae partitioning to Pluronic F68 stabilized foam, liquid recirculation was introduced into the reactor design. The microalgal suspension was continuously pumped from the bottom of the reactor to the top of the foam column where it was allowed to drain down again through the foam. This new design allowed increased mixing and, thereby, a homogenous algae distribution within the reactor. The volumetric mass transfer coefficient for CO2 in the foam-bed was 0.14 s−1, revealing that the gas transfer rate is an order of magnitude higher compared to bubble column reactors. This characteristic, together with a very high gas residence time, allows for a dramatic reduction in gas flow rate and a high carbon dioxide utilization efficiency. Long-term cultivation (>500 h) of Chlorella sp. was achieved in a stable foam-bed. The areal productivity of the foam-bed photobioreactor was 57 g m−2 d−1, which is slightly lower than maximally achieved in flat panels under similar conditions. This is possibly related to substantial light scattering taking place in the foam leading to a steeper light gradient and increased reflection. The reactor dilution rate and the liquid recirculation rate were not optimized during our experiments and there is room for further improvement. During continuous reactor operation, biomass densities of >20 g L−1 could be maintained. This biomass density is a factor of 10 higher compared to traditional, liquid phase photobioreactors, thereby, contributing to reduced energy requirements for microalgae harvesting.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Algal Research - Volume 33, July 2018, Pages 55-70
نویسندگان
, , , , , ,