Experimental study of directional propagation of hydraulic fracture guided by multi-radial slim holes

The conventional hydraulic fracturing fails in the target oil/gas zone (remaining oil, closed reservoir, etc.) which is not located in the azimuth of maximum horizontal stress of available wellbores. The technology of directional propagation of hydraulic fracture guided by vertical multi-radial slim holes is innovatively developed. In order to verify this technology, lots of true triaxial hydraulic fracturing simulation experiments were carried out with artificial cores, aiming at investigating the influence of in-situ stress, fracturing fluid displacement, and azimuth, diameter, number, and spacing of radial slim holes on fracture propagation. The results show that directional propagation of hydraulic fractures guided by vertical multi-radial slim holes is feasible. Regardless of varied radial slim hole and in-situ stress parameters, hydraulic fracture always initiates in the heel of radial slim hole. For hydraulic fracturing assisted by single radial slim hole, smaller horizontal stress difference (3 MPa, σH/σh = 1.25) and smaller radial slim hole azimuth (15°) may guide propagation of hydraulic fractures along radial slim hole, and larger horizontal stress difference (6 MPa, σH/σh = 1.67) can sharply reduce guidance of radial slim hole. Affected by mutual interference from guidance of radial slim holes and controlling of horizontal in-situ stress, fractures tend to distort along fracture length and fracture height. For hydraulic fracturing assisted by vertical multi-radial slim holes, horizontal stress difference is one of key factors influencing the directional propagation effect of hydraulic fracture. Larger horizontal in-situ stress difference (>6 MPa, σH/σh > 1.67) hardly results in directional propagation of hydraulic fracture along radial slim hole row, and creates bigger diversion angle of fracture, and larger azimuth (>45°) of radial slim hole row reduces the guidance strength, resulting small fracture diversion radius. In conditions of larger angle between target zone and maximum horizontal stress, and requirement of large azimuth of radial slim hole row, the effective hydraulic fracture propagation along radial slim holes and ideal fracture height will be achieved through human intervention, e.g. increment of the number and diameter of radial slim holes, reduction of radial slim holes spacing, increment of fracturing fluid displacement, etc. The simulation results provide methods for designing directional propagation of hydraulic fractures guided by vertical multi-radial slim holes.