Compression of surface EMG signals with algebraic code excited linear prediction

Despite the interest in long timescale recordings of surface electromyographic (EMG) signals, only a few studies have focused on EMG compression. In this paper we investigate a lossy coding technique for surface EMG signals that is based on the algebraic code excited linear prediction (ACELP) paradigm, widely used for speech signal coding. The algorithm was adapted to the EMG characteristics and tested on both simulated and experimental signals. The coding parameters selected led to a compression ratio of 87.3%. For simulated signals, the mean square error in signal reconstruction and the percentage error in average rectified value after compression were 11.2% and 4.90%, respectively. For experimental signals, they were 6.74% and 3.11%. The mean power spectral frequency and third-order power spectral moment were estimated with relative errors smaller than 1.23% and 8.50% for simulated signals, and 3.74% and 5.95% for experimental signals. It was concluded that the proposed coding scheme could be effectively used for high rate and low distortion compression of surface EMG signals. Moreover, the method is characterized by moderate complexity (approximately 20 million instructions/s) and an algorithmic delay smaller than 160 samples (∼160 ms).