Automatic microemulsion preparation for metals determination in fuel samples using a flow-batch analyzer and graphite furnace atomic absorption spectrometry

The principal thermodynamic advantages of using microemulsions over standard emulsions for flow metal analysis are the greatly increased analyte stability and emulsive homogeneity that improve both the ease of sample preparation, and the analytical result. In this study a piston propelled flow-batch analyzer (PFBA) for the determination of Cu, Cr and Pb in gasoline and naphtha by graphite furnace atomic absorption spectrometry (GF AAS) was explored. Investigative phase modeling for low dilution was conducted both for gasoline and naphtha microemulsions. Rheological considerations were also explored including a mathematical flow derivation to fine tune the system's operational parameters, and the GF AAS coupling. Both manual and automated procedures for microemulsion preparation were compared. The results of the paired t test at a 95% confidence level showed no significant differences between them. Further recovery test results confirmed a negligible matrix effect of the sample on the analyte absorption signals and an efficient stabilization of the samples (with metals) submitted to microemulsion treatment. The accuracy of the developed procedure was attested by good recovery percentages in the ranges of 100.0 ± 3.5% for Pb in the naphtha samples, and 100.2 ± 3.4% and 100.7 ± 4.6% for Cu and Cr, respectively in gasoline samples.

Figure optionsDownload as PowerPoint slideHighlights
► Micro-emulsion composition phase study to obtain low fuel dilutions.
► Automated and instantaneous in-line preparation of micro-emulsions for metals determinations.
► A versatile piston-driven form of “Flow-batch Analysis”.
► Rheological considerations explored including a mathematical derivation of flow parameters.