Optimizing gas chromatographic–mass spectrometric analysis of selected pharmaceuticals and endocrine-disrupting substances in water using factorial experimental design

An analytical method based on gas chromatography–mass spectrometry (GC–MS) has been developed to simultaneously determine selected acidic and neutral pharmaceuticals and endocrine-disrupting substances in surface and tap water. Solid-phase extraction (SPE) with Oasis HLB cartridges is followed by derivatization of the target analytes in the eluted extract. Derivatization was systematically optimized by employing a factorial experimental design. More specifically a central composite design was applied to search for the optimal conditions of the derivatization process and it was demonstrated that N-methyl-N-tert-butyl-dimethysilyl-trifluoroacetamide (MTBSTFA) had a better overall performance compared to N,O-bis(trimethylsilyl) trifluoroacetamide (BSTFA). The influence of solvent ratios and elution volumes while using SPE were also studied using a factorial design. The method was developed successfully for most of the selected compounds [i.e. ibuprofen, salicylic acid, gemfibrozil, naproxen, triclosan, propranolol, diclofenac, carbamazepine, 4-octylphenol (OP), 4-nonylphenol (NP), nonylphenol-monoethoxylate (NP1EO), nonylphenoxyacetic acid (NP1EC), estrone (E1), and 17α-ethinyloestradiol (EE2)]. Relative recoveries for spiked river and tap water ranged from 47 to 130% and 60–109%, respectively. Typical limits of detection were less than 5 ng/L in tap water and less than 10 ng/L in river water. Twelve target compounds were detected in river and tap water samples using the developed method. This method is currently used in bench-scale drinking water treatment studies.