Development of a microbioreactor with ecto-nucleoside triphosphate diphosphohydrolase 2 (NTPDase2) immobilized on a polyacrylamide-coated capillary at the outlet

A simple and fast method of immobilization of cell membrane suspension containing human ecto-nucleoside triphosphate diphosphohydrolase 2 (NTPDase2) on a polyacrylamide-coated capillary was developed. The enzyme microbioreactor was prepared by hydrodynamic injection of a small plug of the polycationic electrolyte hexadimethrine bromide (HDB) followed by a suspension of an enzyme-containing membrane preparation. In order to shorten the enzyme assay time and to increase the throughput of the assay, the capillary was coated from the outlet end and all injections were performed from the outlet end of the capillary. For the monitoring of the enzymatic reaction, the substrate ATP dissolved in reaction buffer (140 mM NaCl, 5 mM KCl, 1 mM MgCl2, 2 mM CaCl2, and 10 mM Hepes, pH 7.4, internal standard: 10 μM UMP) in the absence or presence of inhibitor was injected electrokinetically and incubated in the microbioreactor for 1 min with 1 kV of applied voltage. Then, the electrophoretic separation of the reaction products was initiated by applying a constant current of 60 μA. A 50 mM phosphate buffer (pH 6.5) was used for the separations and the products were detected by UV absorbance at 260 nm. The new method was compared with an at-capillary-inlet method without immobilization of the enzyme. The results (Km values, Ki values for inhibitor) obtained with both methods were similar and comparable with literature data. The developed outlet immobilized enzyme microreactor using a coated capillary is very fast, simple and most economic allowing multiple use of the enzyme.