Particle sample introduction system for inductively coupled plasma–atomic emission spectrometry

Development and characterization of a new, relatively inexpensive, computer-controlled, particle sample introduction (PSI) system for programmable delivery of small amounts of diluted powdered samples into an inductively coupled plasma (ICP) and measurement by atomic emission spectrometry (AES) is described. The PSI was developed for use with non-hygroscopic particles, in particular those with a particle weight in the ng range (i.e., with a diameter in low μm-range) and for solids that can be converted to a powder (i.e., a collection of particles). In this first report on PSI–ICP–AES, linearity of calibration curves and plasma loading concerns were addressed using three modes of operation. In the first mode, the PSI operated similar to a nebulizer and it delivered to the plasma for a period of 5–10 s a relatively constant amount of particles diluted with graphite. In the second mode, the PSI delivered to the plasma a small “puff” of a diluted sample, thus generating a transient, time-domain signal with duration of about a second. In the third mode, an even smaller “puff” was delivered to the plasma and, using high-speed data acquisition (in the kHz range), time-resolved emission signals from individual, μm-diameter and ng-weight particles were observed. Thus, the PSI can also be thought of as a nano-particle (i.e., ng rather than nm) sample introduction system. Similarly, the high-speed, wide-bandwidth single-channel time-resolved data acquisition mode enabled the determination of particle-size distribution. In addition, a dual-channel (or dual-element) mode enabled homogeneity studies on a per-individual-particle basis. In all modes, linear calibration curves were obtained (provided that plasma loading was avoided). Per-cent relative standard deviation ranged between 3.1% and 4.2% for Ni in certified reference materials but was as high as 50% for heterogeneous soil samples. Tungsten emission signals from refractory tungsten carbide powders were enhanced using mixed gases and by modifying the chemical environment of the ICP using SF6. Furthermore, when coupled with high-speed data acquisition, PSI brought unique capabilities to ICP–AES for homogeneity studies from individual ng-weight particles and for the determination of particle size distributions. Overall, it was concluded that PSI is an attractive alternative to powder sample introduction systems described in the literature.