Effect of surfactants on the voltammetric response and determination of an antihypertensive drug

The effect of adding surface-active agents to electrolytes containing terazosin, an antihypertensive drug, on the voltammetric response of glassy carbon electrode was studied. The current signal due to the oxidation process was a function of the amount of terazosin, pH of the medium, type of surfactant, and accumulation time at the electrode surface. Two surfactants were used, an anionic type, sodium dodecyl sulfate (SDS) and a cationic type, cetyl trimethyl ammonium bromide (CTAB). Addition of SDS to the terazosin-containing electrolyte was found to enhance the oxidation current signal while CTAB showed an opposite effect. Beside the interfacial interaction of the surfactant with the electrode surface in reference to the bias applied potential and the charge of surfactant, terazosin-surfactant interaction in the electrolytic solution was found to be critical to the magnitude of current signal. Addition of SDS to terazosin-containing buffer solution resulted in a decrease in the drug absorption spectrum both in the ultra-violet and visible (UV–vis) regions. Moreover, NMR measurements showed considerable chemical shifts for the aromatic protons of the quinazolinyl moiety of the terazosin in presence of SDS. The affected aromatic protons are positioned next to the interacting protonated amino-group of the terazosin with the charged sulfonate-group of SDS. On the other hand, addition of CTAB did not cause noticeable changes both to the UV–vis and NMR spectra of the drug. The use of SDS in the electrochemical determination of terazosin using linear sweep voltammetry and differential pulse voltammetry at solid glassy carbon electrode enhanced the detection limit from 6.00 × 10−7 mol L−1 in absence of surfactant to 4.58 × 10−9 mol L−1 when present. The validity of using this method in the determination of drug active ingredient in urine samples and tablet formulations was also demonstrated.