کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
1386743 982531 2007 10 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Comparison of methods to determine the degree of gelatinisation for both high and low starch concentrations
موضوعات مرتبط
مهندسی و علوم پایه شیمی شیمی آلی
پیش نمایش صفحه اول مقاله
Comparison of methods to determine the degree of gelatinisation for both high and low starch concentrations
چکیده انگلیسی

A general procedure was developed to measure the degree of gelatinisation in samples over a broad concentration range. Measurements based on birefringence, DSC (Differential scanning calorimetry), X-ray and amylose–iodine complex formation were used. If a 10 w/w % wheat starch–water mixture was used, each method resulted in approximately the same degree of gelatinisation vs. temperature curve. In case the gelatinisation of a 60 w/w % wheat starch–water mixture was followed as a function of the temperature, each method resulted in a different degree of gelatinisation vs. temperature curve. DSC and X-ray measurements are preferred, because they can be used to determine when the final stage of the gelatinisation process has been completed. Birefringence and amylose–iodine complex formation measurements are suitable alternatives if DSC and X-ray equipment is not available, but will lead to different results. The differences between the methods can be explained by considering the phenomena that take place during the gelatinisation at limiting water conditions.Based on the experimental data obtained with DSC and X-ray measurements, the gelatinisation of 10 w/w % and 60 w/w % wheat starch–water mixtures started at the same temperature (approximately 50 °C). However, complete gelatinisation was reached at different temperatures (approximately 75 °C and 115 °C for, respectively, 10 w/w % and 60 w/w % wheat starch–water mixtures) according to the experimental DSC and X-ray data. These results are in accordance with independent DSC measurements that were carried out.The Flory equation was adapted to provide a quantitative explanation for the curves describing the degree of starch gelatinisation as a function of the starch–water ratio and the temperature. The gelatinisation curves that were obtained with the model are in good agreement with the experimentally determined curves. The parameters Tm0, ΔHu and χ12 that resulted in the lowest sum of the squared residuals are 291 ± 63 °C, 29.2 ± 3.9 kJ/mol and 0.53 ± 0.05 (95% confidence interval). These values agree with other values reported in literature.

ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Carbohydrate Polymers - Volume 67, Issue 4, 19 February 2007, Pages 481–490
نویسندگان
, , , , ,