Three-dimensional shear-strain patterns induced by high-pressure torsion and their impact on hardness evolution

The shear strain imposed on austenite/ferrite duplex stainless steel discs at different stages of high-pressure torsion (HPT) processing was imaged in plan-view and cross-section using optical microscopy and scanning electron microscopy. The effect of the shear strain was correlated to the hardness evolution of the discs. The shear-strain patterns are complex and are different on the top and bottom surfaces of the discs. A double-swirl pattern emerged on the top surface in the early stages of HPT. These two centres of the swirl moved towards the centre of the disc as the numbers of HPT revolutions was increased and ultimately the double-swirl evolved into a single-swirl. Less regular shear-strain patterns were observed on the bottom surfaces of the discs. Multiple ring-like patterns with mirror symmetry over the central axes of the discs were visible from cross-sectional observations. Nanoindentation testing on the two surfaces and a cross-section of HPT discs showed that the hardness is insensitive to specific shear-strain patterns, but is closely related to the widths of the austenite and ferrite phase domains. Late in the deformation process, the hardness in the interior of an HPT disc may be higher than at either of the disc surfaces because of the development of finer microstructural phase distributions.

► Three-dimensional shear strain patterns were evaluated during high-pressure torsion.
► Double-swirl patterns are visible on the top surfaces of discs in early stages of HPT.
► Double-swirls ultimately evolve into a single swirl with increasing revolutions.
► Microstructural evolution in HPT may deviate initially from rigid-body situation