Improved superconducting properties of MgB2 thin films fabricated by ultrasonic spray pyrolysis method at high temperature

High quality MgB2 superconducting thin films have been successfully prepared by 2.4 MHz ultrasonic spray pyrolysis (USP) system on single crystal Al2O3 (0 0 1) substrates. The microstructure, electrical and magnetic properties of approximately 500–600 nm thick films were investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM) in conjunction with the energy dispersive X-ray analysis (EDX), resistance versus temperature (R–T) and magnetization measurements (M–H) under different magnetic fields and transport critical current density (Jc). Films were first heat treated in situ in the spraying chamber with an extra Mg powder during deposition to compensate excess evaporation of Mg from the films and then additionally heat treated in Ar atmosphere at 700 °C for a short time. According to the results obtained, orientation on any particular direction for the crystal growth was not seen. Homogeneous, highly dense and highly smooth surface morphology and low resistance have been achieved under optimum conditions. Optimally treated films exhibited relatively high transport critical current density of 2.37 × 105 A cm−2. These results have been also compared with the Jcmag results calculated from the M–H curves. The electrical resistance property of the best samples was obtained to be 39.5 and 37.4 K for Tc and Tzero, respectively.

► Ultrasonic spray pyrolysis (USP).
► MgB2 superconductor.
► Superconducting thin film.
► Critical current density, Jc.
► Magnetization properties of MgB2 thin films.