کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
213897 1425796 2015 8 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Metallic tin recovery from wave solder dross
ترجمه فارسی عنوان
بازیافت فلز قلع از جوش سرامیکی موج
کلمات کلیدی
لحیم کاری بدون سرب، جوش لحیم کاری موج، اکسید قلع
موضوعات مرتبط
مهندسی و علوم پایه مهندسی شیمی مهندسی شیمی (عمومی)
چکیده انگلیسی


• Recovery of metallic tin from scrap generated in lead-free wave solder was studied.
• Metallic tin surrounded by tin oxide was the predominant observed phase in the scrap.
• Thin films of tin oxide prevented the coalescence and recovery of the metallic tin.
• Removal of the oxide film is the key step required in recovering the metallic tin.
• A low temperature processes was proposed consisting of grinding and acid dissolution.

Lead-free solders used in electronic components are predominately composed of alloys rich in tin. Significant quantities of partially oxidized tin alloy are generated during typical processing operations. The scrap has generally been considered to be tin oxide and suitable for recovery using electrolysis or reduction with charcoal and fuel oil at temperatures above 1000 °C. This experimental work examines alternative processes for the recovery of metallic tin from this scrap. Microstructural and chemical characterisation of the scrap revealed that metallic tin was the predominant phase and was surrounded by a cover layer of tin oxide ranging in thickness from a few μm (micrometres) to 100 μm. It was shown that even the thin layer of tin oxide prevented the coalescence of the metallic tin and inhibited recovery. It was concluded that removal of the oxide layer is the key step required in recovering the metal. The removal of the tin oxide was attempted using mechanical attrition (grinding in a ball mill) and chemical dissolution of the tin oxide layer by means of hydrochloric acid (HCl). The results of attrition in a ball mill indicated that the tin oxide covering layer was effectively reduced from the material over 53 μm and the removed oxide was concentrated in particles less than this size. Furthermore, the remaining tin oxide layer can be almost completely removed by an acidic treatment with 2 M HCl at room temperature and agitation for 30 min. A flow sheet for the recovery of the metallic tin is presented below based on the obtained experimental results.

Figure optionsDownload as PowerPoint slide

ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: International Journal of Mineral Processing - Volume 137, 10 April 2015, Pages 98–105
نویسندگان
, , ,