Treatment of bleomycin-induced pulmonary fibrosis by inhaled tacrolimus-loaded chitosan-coated poly(lactic-co-glycolic acid) nanoparticles

Pulmonary fibrosis is a chronic lung disease characterized by inflammation and collagen deposition, with an estimated mortality rate exceeding 70%. Here, we evaluated the therapeutic effectiveness of inhaled tacrolimus-loaded chitosan-coated poly(lactic-co-glycolic acid) nanoparticles (chitosan TAC PLGA-NPs) in a bleomycin-induced pulmonary fibrosis mouse model. Chitosan TAC PLGA-NPs were fabricated using an o/w emulsification diffusion method, and uncoated TAC PLGA-NPs and chitosan TAC PLGA-NPs were spherical with approximate diameters of 320 and 441 nm, respectively. The zeta potential of chitosan TAC PLGA-NPs (+13.6 mV) was increased significantly by chitosan-coating versus uncoated TAC PLGA-NPs (−28.3 mV). The incorporation efficiency of tacrolimus was 37.7%, and the tacrolimus was gradually released until about 5 day. Direct inhalation of chitosan TAC PLGA-NPs (TAC 180 μg/mouse) twice a week produced marked anti-fibrotic efficacy in mice with bleomycin-induced pulmonary fibrosis, which was much better than the efficacy resulting from daily oral administration (TAC 300 μg/mouse) on the basis of hematoxylin/eosin and Masson’s trichrome staining assessments. Imaging of lung deposition showed that chitosan TAC PLGA-NPs were located well in the lungs and gradually faded over 96 h. The pulmonary delivery of tacrolimus could be therapeutically efficacious for treating pulmonary fibrosis. TAC-loaded PLGA nanoparticles should be considered to be an efficient sustained-release type inhalation system that reduces administration frequency and relevant side effects.