کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
267648 504407 2012 8 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Inelastic buckling design of monosymmetric I-beams
موضوعات مرتبط
مهندسی و علوم پایه علوم زمین و سیارات مهندسی ژئوتکنیک و زمین شناسی مهندسی
پیش نمایش صفحه اول مقاله
Inelastic buckling design of monosymmetric I-beams
چکیده انگلیسی

Methods of designing steel monosymmetric I-beams against lateral buckling are not well supported by research. For this paper, the inelastic buckling of monosymmetric steel I-beams under moment gradient is studied and compared with design recommendations.For welded beams in uniform bending, inelastic buckling is initiated at moments which are often close to those which cause first yield in the compression flange. Once initiated, the inelastic buckling resistance remains constant as the slenderness decreases until strain-hardening occurs. For hot-rolled beams in uniform bending, the inelastic buckling resistance increases almost linearly as the slenderness decreases.Three regimes are significant in the inelastic buckling resistances of hot-rolled monosymmetric beams under moment gradient, depending on which flange yields first and the end moment ratio.Simple linear approximations of good accuracy are developed for designing hot-rolled monosymmetric beams in uniform bending, while less accurate but conservative approximations are developed for moment gradient. The use of these approximations is illustrated by a worked example.


► Studies inelastic buckling resistance of monosymmetric steel beams.
► Resistances of welded beams are largely independent of slenderness.
► Resistances of hot-rolled beams decrease linearly with slenderness.
► Resistances increase with compression flange size and moment gradient.
► Simple design approximations are developed.

ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Engineering Structures - Volume 34, January 2012, Pages 564–571
نویسندگان
,