Debris extrusion by glide-path establishing endodontic instruments with different geometries

Background/purposeGlide-path preparation is an important step during initial endodontic procedure to reduce shaping-instrument fracture. The aim of this study was to evaluate the amount of apically extruded debris produced by glide-path preparation instruments with different geometric designs.Materials and methodsForty teeth extracted for periodontal reasons were randomly divided into four groups (n = 10). The working length was standardized at 17 mm from the apical foramen by a flattening reference point. The glide-path was created using repetitive up-and-down movement three times with one of following four selected instruments: One G, ProGlider, a size 15 ScoutRace, and a size 15 stainless-steel K-file. To collect the apically extruded debris, the customized apparatus was used, and the collected debris was stored in an incubator. The weight of the debris was measured using an analytical balance with an accuracy of 0.00001 g. The data were analyzed by one-way analysis of variance and Duncan's multiple comparison test at a significance level of 95%.ResultsThe ProGlider group produced significantly less debris extrusion relative to the other groups (P < 0.05). The One G and ScoutRace groups showed no significant difference, but debris production was lower than that observed for the stainless-steel group (P < 0.05).ConclusionCreating the glide-path using nickel-titanium rotary files produced lower amounts of debris extrusion than using manual stainless-steel files. The progressive taper design of ProGlider, the center-off cross-section of One G, and the alternative-pitch design of ScoutRace may have increased the efficiencies of debris removal with minimal extrusion during glide-path preparation. Glide-path preparation using NiTi rotary files have better clinical efficiency than the manual stainless-steel file.