Flexural strength of veneering ceramics for zirconia

ObjectivesThe flexural strengths of veneering ceramics for zirconia were compared.MethodsWith 10 different veneering ceramics for zirconia (test group) and three different veneering ceramics for the metal-ceramic technique (control group) three-point flexural strength and biaxial flexural strength according to ISO 6872: 1995 as well as four-point flexural strength according to EN 843-1: 2005 were measured (n = 10). Statistical analysis was performed with one-way ANOVA and post hoc Scheffé test (SPSS, p < 0.05).ResultsFor the test group, three-point flexural strength ranged between 77.8 ± 8.7 and 106.6 ± 12.5 MPa without any statistically significant differences, biaxial flexural strength between 69.1 ± 4.8 and 101.4 ± 10.5 MPa with three homogeneous groups and four-point flexural strength between 59.5 ± 6.2 and 89.2 ± 9.5 MPa with five homogeneous groups. The control group showed three-point flexural strength values ranging from 93.3 ± 13.5 to 149.4 ± 20.5 MPa, biaxial flexural strength values from 93.4 ± 10.0 to 141.2 ± 11.6 MPa, and four-point flexural strength values from 82.7 ± 8.5 to 116.9 ± 9.8 MPa. In every case, the results of the four-point flexure test were significantly lower than those obtained in the three-point flexure test. The three-point flexural strengths of the test group are similar to those of two ceramics of the control group. The flexural strength of one ceramic of the control group significantly exceeded the strengths of all other ceramics investigated.ConclusionThree-point flexural strength values of veneering ceramics for zirconia are similar to those of veneering ceramics for the metal-ceramic technique. The four-point flexure test among all three tests showed highest discrimination between the different ceramic materials.