Comparison of Magnetic Resonance Imaging With Radionuclide Methods of Evaluating the Kidney

Nuclear medicine and MRI provide information about renal perfusion, function (glomerular filtration rate), and drainage. Some tracers that are used in nuclear medicine (technetium-diethylene triamine pentaacetic acid ([99mTc-DTPA] and 51chromium-EDTA) and some contrast media (CM) that are used for MRI (gadolinium-DTPA for instance) share the same pharmacokinetic properties, though, detection techniques are different (low-spatial resolution 2-dimensional projection with a good concentration-to-signal linearity for nuclear medicine and high-resolution 3-dimensional localization with nonlinear behavior for MRI). Thus, though based on the same principles, the methods are not the same and they provide somewhat different information. Many MRI perfusion studies have been conducted; some of them were compared with nuclear medicine with no good agreement. Phase contrast can reliably assess global renal blood flow but not perfusion at a tissular level. Arterial spin labeling has not proven to be a reliable tool to measure renal perfusion. Techniques using CM theoretically can assess perfusion at the tissular level, but they have not proven to be precise. To assess renal function, many models have been proposed. Some MRI techniques using CM, both semiquantitative (Patlak) and quantitative, have shown ability to roughly assess relative function. Some quantitative methods (Annet's and Lee's methods) have even showed that they could roughly estimate absolute renal function, with better results than estimated glomerular filtration rate. Quantification of drainage has not been much studied using MRI.