کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
4449730 1620510 2015 9 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Influence of operating conditions on chemical composition of particulate matter emissions from residential combustion
ترجمه فارسی عنوان
تأثیر شرایط عملیاتی بر ترکیب شیمیایی انتشار گازهای گلخانه ای از احتراق مسکونی
موضوعات مرتبط
مهندسی و علوم پایه علوم زمین و سیارات علم هواشناسی
چکیده انگلیسی


• Chemical composition of particles from distinct operating conditions was studied.
• Organic carbon contributes to more than 30% of the PM10 mass.
• K, Ca, Na, Mg, Fe and Al were the dominant trace elements in smoke particles.
• PM10 composition can vary greatly with operating conditions.

Wood combustion experiments were carried out in a Portuguese woodstove to determine the effects of biofuel type, ignition technique, biomass load and cleavage, as well as secondary air supply, on the chemical composition of particles (PM10). Two typical wood fuels in the Iberian Peninsula were tested: pine (Pinus pinaster), a softwood, and beech (Fagus sylvatica), a hardwood. PM10 samples were analysed for organic and elemental carbon (OC and EC), levoglucosan and 56 elements. Total carbon (TC) represented 54–73 wt.% of the particulate mass emitted during the combustion process, regardless of wood species burned or operating condition tested. The carbonaceous component of PM10 was dominated by OC. The OC content of PM10 was higher when higher loads were fed into the combustion chamber, for both fuels. EC represented from 8 to 35 wt.% of the particulate mass. OC/EC ranged from 1.1 to 6.1 (avg. 3.0 ± 1.8) for pine combustion and from 1.1 to 3.4 (avg. 2.0 ± 0.8) for beech combustion. The lowest OC/EC ratios for both woods were observed for ignition from the top. Levoglucosan was found in all samples, representing from 3.7 to 7.5 wt.% and from 4.2 to 8.9 wt.% of PM10 emitted from the combustion of pine and beech, respectively. The use of low loads of fuel generated high amounts of levoglucosan either for pine or beech. Altogether, trace elements obtained by ICP-MS and ICP-AES comprised from 0.46 wt.% to 1.41 wt.% and from 0.87 wt.% to 2.36 wt.% of the PM10 mass for pine and beech combustion, respectively. Among elements, K, Ca, Na, Mg, Fe and Al contributed to more than 75% of the total ICP-MS mass. Potassium was the major element in almost all PM10 samples.

ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Atmospheric Research - Volume 166, 1 December 2015, Pages 92–100
نویسندگان
, , , , , , , , , ,